FN3440FN3440

Ecosine Evo FN3440

Ecosine evo,400 VAC 50 Hz 全性能无源谐波滤波器

FN3440

Ecosine evo,400 VAC 50 Hz 全性能无源谐波滤波器

  • 6脉冲整流器和电机驱动器的行业标准
  • 用于无DC-link电抗器的二极管整流器和晶闸管整流器的滤波器
  • 同类最佳的部分负载性能
  • 最紧凑的设计
  • 即插即用,可直接使用

 

  • 工业标准。

Features and Benefits

夏弗纳EOCsine谐波滤波器是应对三相电力系统中负载谐波补偿挑战的一种经济解决方案。由于采用了即插即用的方法,而且尺寸比同类产品更紧凑,它们可以快速安装并轻松调试。它们提高了电力设施的可靠性和使用寿命,有助于更好地利用电力系统的容量,并且是满足IEEE 519等电能质量标准的关键。正弦波滤波器能将失真的电流重新塑造为所需的正弦波形。夏弗纳正弦滤波器几乎可以应用于任何带有前端六脉冲整流器、三相二极管或晶闸管桥的电力电子装置,在这些装置中,需要将谐波电流失真降低到规定的限度。

Typical Applications

带有前端六脉冲整流器的设备
电机驱动
工厂自动化设备
水/废水处理设施
风扇和泵的应用
HVAC安装
关键任务过程
直流快速充电器
<

Technical Specifications

Nominal operating voltage

3 x 380 VAC to 415 VAC ±10%

Operating frequency

50 Hz ±1 Hz

Nominal motor drive input power rating

1.1 to 250 kW

Total harmonic current distortion THDi*

≤5% at rated power

Total demand distortion TDD

According to IEEE 519

Efficiency

>98% for rated voltage and power

Overload capability

1.6x rated current for 1 minute, once per hour

SCCR**

100 kA

High potential test voltage

P –> E 2160 VAC (1 s)

Overvoltage category

OV III (IEC 60664-1 / UL 61800-5-1)

Earthing System

TN, TT, IT

Protection category

IP 00, IP 20

Cooling

Internal fan cooling or external cooling***

Ambient temperature range

–25°C to +45°C fully operational

+45°C to +70°C derated operation****

–25°C to +85°C transport and storage

Design corresponding to

Filter: UL 61800-5-1, EN 61800-5-1

Chokes: EN 61558-2-20 or EN 60076-6

Flammability corresponding to

UL 94 V-2

MTBF @ 45°C/400 V (Mil-HB-217F)

> 200'000 hours

* 系统要求。THDv<2%,线路电压不平衡<1%。 注意:本手册中的性能规格是指六脉冲二极管整流器。 可控硅整流器前端会产生不同的结果,取决于晶闸管的触发角。 滤波器的额定功率下THDi~5%,<6 kW/HP ** 需要外部UL等级的保险丝。请查阅用户手册。 *** 请在本文件和用户手册中进一步检查冷却表所需的入口空气流量。 **** Iderated = Inominal*SQRT((Tmax-Tamb)/(Tmax-Tnominal)) = Inominal*SQRT((70℃-Tamb)/25℃)
* System requirements: THDv <2%, line voltage unbalance <1% Note: performance specifications in this brochure refer to six-pulse diode rectifiers. SCR rectifier front-ends will produce different results, dependent upon the firing angle of the thyristors. THDi ~5% at rated power for filter <6 kW/HP ** External UL-rated fuses required. Please consult the user manual. *** Please check the inlet air flow required for cooling table further in this document and the user manual. **** Iderated = Inominal*SQRT((Tmax-Tamb)/(Tmax-Tnominal)) = Inominal*SQRT((70°C-Tamb)/25°C)

Typical electrical schematic

FN3440

Approvals & Compliances

CE Label
UKCA Label
RoHS Label
UL Listed USA Label
UL Recognized Label (USA)

(depending on filter configuration)

Back